Home
Welcome to the ESP32-Serial-Bridge wiki!
ESP32-Serial-Bridge Transparent WiFi (TCP) to all three UART Bridge, supports both AP and STATION WiFi modes. The .ino file is the code for the ESP32. Use Arduino IDE for ESP32 to compile and upload it to the ESP32. I made this project in order to connect Flight equipment devices devices like (Radio, Vario FLARM), to a Flight Computer (Kobo, Smartphones etc.), but it is not limited to that. You can use it wherever you want, but on your own risk. Read license file for more details. Accesspoint IPAdress: 192.168.4.1 AP SSID: LK8000 AP Password: Flightcomputer Used Ports: 192.168.4.1:8880 <-> COM0 192.168.4.1:8881 <-> COM1 192.168.4.1:8882 <-> COM2
Used Libraries: (must be installed in the arduino IDE):
https://github.com/espressif/arduino-esp32
===============================================================
In some cases the memorylayout is to small for this scetch. If you face this problem you can either disable Bluetooth by removing #define BLUETOOTH in config.h or change the partition size as described here: https://desire.giesecke.tk/index.php/2018/04/20/change-partition-size-arduino-ide/
example usecases:
https://www.youtube.com/watch?v=K2Hia06IMtk
https://www.youtube.com/watch?v=GoSxlQvuAhg
Hardware here is the wiring diagram recomendation: https://raw.githubusercontent.com/AlphaLima/ESP32-Serial-Bridge/master/ESP32-SerialBridge.jpg Pinning
- COM0 Rx <-> GPIO21
- COM0 Tx <-> GPIO01
- COM1 Rx <-> GPIO16
- COM1 Tx <-> GPIO17
- COM2 Rx <-> GPIO15
- COM2 Tx <-> GPIO04
NOTE: The PIN assignment has changed and may not look straigt forward (other PINs are marke as Rx/Tx), but this assignment allows to flash via USB also with hooked MAX3232 serial drivers.
I recomend to start your project with a Node32s or compatible evaluation board. For a TTL to RS232 level conversion search google for "TTL RS3232 Converter"
A discussion incl. the similar ESP8266 projekt can be found here: