You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a version of the lanbon L8 switch, but with 4 light relays instead of 3. All 4 relays fire with the original firmware.
I have been trying to build a version of openhasp with the additional L4 GPIO and/or add it to the webUI configuration/GPIO section but have not had any luck. I know that the GPIO pin is pin 15, as advised by the manufacturer. They also confirmed 12,14 and 27 are the existing pins, which I already knew.
I have tried adding pin 15 output like the other 3 but with no luck. I have also tried adding pin -D RELAY_4 to the lanbon build (and associate line in hasp_gpio.cpp). But no luck.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
I have a version of the lanbon L8 switch, but with 4 light relays instead of 3. All 4 relays fire with the original firmware.
I have been trying to build a version of openhasp with the additional L4 GPIO and/or add it to the webUI configuration/GPIO section but have not had any luck. I know that the GPIO pin is pin 15, as advised by the manufacturer. They also confirmed 12,14 and 27 are the existing pins, which I already knew.
I have tried adding pin 15 output like the other 3 but with no luck. I have also tried adding pin -D RELAY_4 to the lanbon build (and associate line in hasp_gpio.cpp). But no luck.
What am I missing?
Beta Was this translation helpful? Give feedback.
All reactions