Extruder knob for Anycubic i3 Mega
The axle hole is 5.4mm while the axle is 5mm in diameter. Our printer makes holes ~0.2mm too small on each side, so it fits well. You may have to fiddle with the sizing or pad the flat part with some thin metal.
Hotend cooler fan duct for low-power / low-noise Noctua fan.
Uses original screws, does not need the nuts. If necessary, open holes with 2.5mm drill. NB! With 3d-printed hotend cover (2mm walls", the orogonal version did not allow the cover to sit properly. I used hobby knife to original and fixed the model somewhat the same amount. I haven't printed nor tried the fixed version.
Anti-backlash nut for T8x8 lead screw. My lead screws had like 0.5-1mm slack.
3 sizes, S has tightest thread, L the loosest fit. Use the one that fits best and rotates fairly smoothly after passing screw end. Expand XY if none are good. Use M2.5 or M3 screws (drill/tap holes for good fit) to tighten, ~2pcs/nut. Screw tips go to bolt ends and prevent rotation.
Dual-gear extruder using parts from BMG clone and Anycubic i3 Mega (non-S) stock extruder. Easy to load filament ;)
Hot end sides with cooling duct and front leds
NB! Rear part cooler needed, original part cooling cannot be used!
Simple Titan clone - to - direct adapter.
NB Ventilation slots on hotend cover are mostly blocked! NB Max build height is 160mm
Titan + V6/6Lite + dual 4010 part cooling
Handlebar nut for Bosch Rotak 32 electric lawn mover
Remix of https://www.thingiverse.com/thing:4868422 for silicon spacers and rear glass tabs
Titan clone (not inverted) mount for UniTak3D Ender 3 Direct Drive Upgrade Kit Conversion Mount for Ender 3 V2, Ender 3 Pro and Voxelab Aquila 3D Printer Compatible with BMG Dual Drive & Bowden Extruder & Dual Gear Extruder
Orbiter 2.0 extruder mount for UniTak3D Ender 3 Direct Drive Upgrade Kit Conversion Mount for Ender 3 V2, Ender 3 Pro and Voxelab Aquila 3D Printer Compatible with BMG Dual Drive & Bowden Extruder & Dual Gear Extruder
Sliding cover to prevent powering Elegoo Mars 4 with USB stick in it.