diff --git a/Firmware/Kraken/Voron_Trident_Kraken_Config.cfg b/Firmware/Kraken/Voron_Trident_Kraken_Config.cfg
index f6176ce..057fbeb 100644
--- a/Firmware/Kraken/Voron_Trident_Kraken_Config.cfg
+++ b/Firmware/Kraken/Voron_Trident_Kraken_Config.cfg
@@ -22,7 +22,7 @@
 ## Fine tune E steps                    [extruder] section
 
 [mcu]
-##  Obtain definition by "ls -l /dev/serial/by-id/" then unplug to verify
+##  Obtain definition by "ls /dev/serial/by-id/*" then unplug to verify
 ##--------------------------------------------------------------------
 serial: /dev/serial/by-id/{REPLACE WITH YOUR SERIAL}
 restart_method: command
diff --git a/Firmware/Voron_Trident_SKR14_EXPMOT.cfg b/Firmware/Voron_Trident_SKR14_EXPMOT.cfg
index 2516419..ccdb9fe 100644
--- a/Firmware/Voron_Trident_SKR14_EXPMOT.cfg
+++ b/Firmware/Voron_Trident_SKR14_EXPMOT.cfg
@@ -74,7 +74,7 @@ path: ~/gcode_files
 [display_status]
 
 [mcu]
-###Change to device found by "ls -l /dev/serial/by-id/" with just one this MCU connected to Pi
+###Change to device found by "ls /dev/serial/by-id/*" with just one this MCU connected to Pi
 serial: /dev/serial/by-id/usb-Klipper_lpc1769_XXXXXXXXXXXXXXXXXXX
 
 [printer]
diff --git a/Firmware/Voron_Trident_SKR_1.3.cfg b/Firmware/Voron_Trident_SKR_1.3.cfg
index d229b11..6a30097 100644
--- a/Firmware/Voron_Trident_SKR_1.3.cfg
+++ b/Firmware/Voron_Trident_SKR_1.3.cfg
@@ -71,10 +71,10 @@ max_z_accel: 100
 square_corner_velocity: 5.0  
 
 [mcu]
-###Change to device found by "ls -l /dev/serial/by-id/" with just one this MCU connected to Pi
+###Change to device found by "ls /dev/serial/by-id/*" with just one this MCU connected to Pi
 serial: /dev/serial/by-id/usb-Klipper_lpc1768_XXXXXXXXXXXXXXXXXXXXX
 
-###Change to device found by "ls -l /dev/serial/by-id/"" with just one this MCU connected to Pi
+###Change to device found by "ls /dev/serial/by-id/*" with just one this MCU connected to Pi
 [mcu xye]
 serial: /dev/serial/by-id/usb-Klipper_lpc1768_XXXXXXXXXXXXXXXXXXXXX