ESP8266 ------ LC Technology 5V 4 Channel Relay Board (LC-ESP01-4R-5V)

[Abbruscato]

Good morning, I just installed the firmware on an esp8266 that manages 4 5v relays.
Everything configured but I don't know how to do the following:

After a power failure, the programmed functions should resume upon restoration.
How do you set up this feature?
Thank you

[sfromis]

That was a bad board to buy, has caused lots of pain, as it does not allow Tasmota full control.

You may be able to do something with Power2#boot rules to pick up initial power state as seen by Tasmota, and combine that with the existing rules suggested on the template page to replicate Tasmota power state to the commands for the other MCU controlling the board.

[Abbruscato]

Hi, I tried playing with the rules and Power2#boot, but to no avail.
I wanted to thank you for the advice.
Which 4 relay board do you recommend that can be fully managed by Tasmota?
Thank you

[barbudor]

I would suggest this one : https://templates.blakadder.com/robotdyn_ESP32R4.html