[Support]: Birdseye switching cameras very often - single cam view #10836
Unanswered
DrSpaldo
asked this question in
General Support
Replies: 2 comments 1 reply
-
@NickM-27 did you end up getting an opportunity to look at this? |
Beta Was this translation helpful? Give feedback.
1 reply
-
I believe I'm encountering this as well. I have 12 Wyze v3 cameras in my Frigate config, and Birdseye is setup for "motion". I tried overriding one camera's birdseye to "continuous" - intending to have that one camera always visible in one of the four layout slots, and have the other three slots dynamically update based on motion; however, I'm just seeing the camera->slot assignment rearrange a few times per second.
|
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Describe the problem you are having
Since I have changed Birdseye to display 1 camera only, it can change quite often depending on the motion. Sometimes it may flick between cameras 15 times in 10 seconds. So it gets a little crazy and distracting. Is there an option to make it keep the same camera view for x seconds before/without changing?
Version
0.13.2-6476F8A
Frigate config file
Relevant log output
FFprobe output from your camera
Frigate stats
Operating system
Proxmox
Install method
Docker Compose
Coral version
PCIe
Network connection
Wired
Camera make and model
Amcrest, Reolink, etc
Any other information that may be helpful
I have emailed Nick an example CCTV clip of what is happening.
Beta Was this translation helpful? Give feedback.
All reactions