On Windows 10, PulseView don't display waveform

[totuto246]

I installed uLA 0.0.4 on PICO on Windows 10, and it was recognized by PulseView and 16 channels were displayed.
I thought this worked fine, but when I click the RUN button, the waveform trace is not displayed.
Is there anything I should try?

[totuto246]

Additional information:

(1) The version of PulseView is Nightly build for Windows.
It worked fine with the cheep USB logic analyzer using the fx2lafw driver.

(2) I first tried it with Raspberry Pi PICO.
After installing uLA 0.0.4, I installed the WCID Driver in Zadig(PulseView), and then selected the "Openbench Logic Sniffer & SUMP compatible (ols)" driver in PulseView.
The device name changed to "uLA: Micro Logic Analyzer" and 16 channels were displayed.
However, the waveform was not traced even when I clicked the RUN button.

(3) I then tried it with PICO W and RP2040 zero (clone), but it behaved the same as with PICO.

(4) I uninstalled the Nightly builds of PulseView and tried the Release builds of PulseView 0.4.2 (64bit), but the situation did not improve.

[totuto246]

I tried it on another PC with Windows 11 and an RP2040 Zero (clone). The result was the same as above.
I've seen reports that "Raspberry Pi PICO + uLA + PulseView = LogicAnalyzer" works fine on Linux or MAC, but has it worked on Windows10/11?

[Gustavomurta]

Same problem with my Windows 10 PC. I'll test it on Ubuntu and try to understand why it doesn't work on Windows.