-
Notifications
You must be signed in to change notification settings - Fork 37
Replies: 3 comments · 6 replies
-
Connect to the UART console and show the complete log output during boot. |
Beta Was this translation helpful? Give feedback.
All reactions
-
I had bought the PL2303x UART cable which only produced gibberish for me. I wasn't sure what to expect as UART is a new learning curve for me. I have ordered a FT232RL one and hope to be back with a proper output log. |
Beta Was this translation helpful? Give feedback.
All reactions
-
Ok @johang, so new cable finally arrived. At 1.5 Mbaud I managed to capture this log from the COM port:
|
Beta Was this translation helpful? Give feedback.
All reactions
-
These images are very minimal on purpose. You shouldn't expect advanced features to work out of the box. |
Beta Was this translation helpful? Give feedback.
All reactions
-
I waited 4 months to being replied to, and this is what I waited for? No clues, no ideas, just "hey, no advanced features". Having me believe monitor signal is an advanced feature. You could have just said 4 months ago that you don't have the slightest interest to follow up on use cases of your product. |
Beta Was this translation helpful? Give feedback.
All reactions
-
Oh, this is not a product. It's just a personal side project that I spend almost no time on. Any fixes should go into the respective upstream projects. |
Beta Was this translation helpful? Give feedback.
All reactions
-
I could connect to the board using ssh. But just image on the HDMI for a short while. Is it possible to get a text console on the video output? |
Beta Was this translation helpful? Give feedback.
All reactions
-
Text console should be possible using serial monitoring. Cables based on FT232RL chip recommended. |
Beta Was this translation helpful? Give feedback.
All reactions
-
I am delighted to share that this is not a problem with the current build of Ubuntu 25.04. It does show the vertical lines during boot, but it's able to recover from it waking up with a HDMI signal. |
Beta Was this translation helpful? Give feedback.
-
Hi. Awesome work this project is.
I am not getting passed the Uboot screen which ends up with vertical yellow lines allover the screen then powers off the board. What can I try?
Beta Was this translation helpful? Give feedback.
All reactions