You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello, is it possible to "reset" an output to go back to floating state?
Currently whenever we open a pin for output, it either has to go HIGH or LOW, but we want to put it in a floating state for our watchdog. How can we achieve that?
The text was updated successfully, but these errors were encountered:
I have managed to do this using rpio.open(pin.no, INPUT, PULL_OFF);. Hope that is the correct way.
This is not very obvious though, so would be nice if this was documented somehow a bit better in the readme.
Hello, is it possible to "reset" an output to go back to floating state?
Currently whenever we open a pin for output, it either has to go HIGH or LOW, but we want to put it in a floating state for our watchdog. How can we achieve that?
The text was updated successfully, but these errors were encountered: