small lathe big 3-phase stepping motor

[Leygan1]

Hello to all!

Trying to make NanoEls H2 already made the board and now its time for stepper...

I have VRDM 3910/50 for motor its 3f I have and smaller secret brand 3 faze stepper but absolutely no info about it.

For Driver cheapest alliexpres tb6600 buth I want to use Berger LAHR WDP5-228

I am not weary smart in stepper stuff will this assembly will work? if yes I will try to figure out how to set it up.

Gona try this setup on Halifax (Atlas)

[kachurovskiy]

Hi @Leygan1, I've never used steppers and drivers like this so it's very hard to say if they will work together.

Driver seems to support the DIR/PUL 5V logic NanoEls H2 uses as per page 30 of this doc. Page 53 seems to explain which wires to connect Pulse and Direction to. That said the manual is mighty long and I didn't actually read it :)

Cheers!

[Leygan1]

Well yes, the manual is big mostly about serial connection. in Any case, it seems to me that I can't control the 3fhaze stepper with this unit I will have to buy something else :(