platformio_override.ini.sample

# Example PlatformIO Project Configuration Override
# ------------------------------------------------------------------------------
# Copy to platformio_override.ini to activate overrides
# ------------------------------------------------------------------------------
# Please visit documentation: https://docs.platformio.org/page/projectconf.html

[platformio]
default_envs = WLED_tasmota_1M

[env:WLED_tasmota_1M]
board = esp01_1m
platform = ${common.platform_wled_default}
platform_packages = ${common.platform_packages}
board_build.ldscript = ${common.ldscript_1m128k}
lib_deps = ${esp8266.lib_deps}
build_unflags = ${common.build_unflags}
build_flags = ${common.build_flags_esp8266}
; *********************************************************************
; *** Use custom settings from file my_config.h
   -DWLED_USE_MY_CONFIG
; *********************************************************************
;
;
; *** To use the below defines/overrides, copy and paste each onto it's own line just below build_flags in the section above.
; 
; disable specific features
;  -D WLED_DISABLE_OTA
;  -D WLED_DISABLE_ALEXA
;  -D WLED_DISABLE_BLYNK
;  -D WLED_DISABLE_HUESYNC
;  -D WLED_DISABLE_INFRARED
;  -D WLED_DISABLE_WEBSOCKETS
; PIN defines - uncomment and change, if needed:
;   -D LEDPIN=2
;   -D BTNPIN=0
;   -D TOUCHPIN=T0
;   -D IRPIN=4
;   -D RLYPIN=12
;   -D RLYMDE=1
; digital LED strip types - uncomment only one ! - this will disable WS281x / SK681x support
;   -D USE_APA102
;   -D USE_WS2801
;   -D USE_LPD8806
; PIN defines for 2 wire LEDs
   -D CLKPIN=0
   -D DATAPIN=2
; to drive analog LED strips (aka 5050) hardware configuration is no longer necessary
; configure the settings in the UI as follows (hard):
;   for the Magic Home LED Controller use PWM pins 5,12,13,15
;   for the H801 controller use PINs 15,13,12,14 (W2 = 04)
;   for the BW-LT11 controller use PINs 12,4,14,5
;   
; set the name of the module - make sure there is a quote-backslash-quote before the name and a backslash-quote-quote after the name
;   -D SERVERNAME="\"WLED\""
;   
; set the number of LEDs
;   -D DEFAULT_LED_COUNT=30
;   
; set milliampere limit when using ESP pin to power leds
;   -D ABL_MILLIAMPS_DEFAULT=850
;
; enable IR by setting remote type
;   -D IRTYPE=0 ;0 Remote disabled | 1 24-key RGB | 2 24-key with CT | 3 40-key blue | 4 40-key RGB | 5 21-key RGB | 6 6-key black | 7 9-key red | 8 JSON remote
;   
; set default color order of your led strip
;   -D DEFAULT_LED_COLOR_ORDER=COL_ORDER_GRB