Replies: 3 comments 23 replies
-
|
Go to the Releases section from the main page and scroll down. You want the one that start with Ender3S1-F1. The wiki explanation the naming conventions. |
Beta Was this translation helpful? Give feedback.
-
|
Where did you get that screen firmware? Im not 100% sure but I don't think you needed to upgrade that. Which did you do first and what happened after that? |
Beta Was this translation helpful? Give feedback.
-
|
That doesn't look like screen firmware to me but then again I don't have an S1 so not sure. |
Beta Was this translation helpful? Give feedback.
-
|
I got it from the creality site I was trying to follow Mriscoc's instructions |
Beta Was this translation helpful? Give feedback.
-
|
That says it's for an S1 Pro. Do you have the pro with a knob screen? |
Beta Was this translation helpful? Give feedback.
-
|
No I have v3 s1 I heard it was for both. I messed up |
Beta Was this translation helpful? Give feedback.
-
|
No I have v3 s1 I heard it was for both. I messed up
…On Wed, Jan 29, 2025 at 6:40 PM Steve Green ***@***.***> wrote:
That says it's for an S1 Pro. Do you have the pro with a knob screen?
—
Reply to this email directly, view it on GitHub
<#1404 (reply in thread)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/BO6UWTCUK6VCYKYR2IP5RUT2NF7J7AVCNFSM6AAAAABWDCHN2CVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTEMBQGE4DIOI>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
Thank you all for the help I was able to flash the screen, the main board seems to fail but the sd card reader is hit and miss. I am about ready to give it away and take up quilting LOL |
Beta Was this translation helpful? Give feedback.
-
|
Creality has pretty much told me to pound sand as I do not have a receipt. |
Beta Was this translation helpful? Give feedback.
-
|
Don't give up just yet. What is the current status? |
Beta Was this translation helpful? Give feedback.
-
|
Well they’ve blown me off thus far. I’ve been able to get it too this point. |
Beta Was this translation helpful? Give feedback.
-
|
What firmware did you end up putting on the screen? |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
Try this first https://github.com/mriscoc/Ender3V2S1/wiki/How-to-update-the-display#dacai-firmware-update |
Beta Was this translation helpful? Give feedback.
-
|
I will thank you. Will look tomorrow gotta hit the sack |
Beta Was this translation helpful? Give feedback.
-
Good Morning,
I am sorry if this sounds dumb but, I cannot figure out how to Download the Latest firmware for my Printer. the Chip has a 103 on it.
I am new to this. I know it is old and I should have done more research before I bought it .
Thank you
Beta Was this translation helpful? Give feedback.
All reactions