[MK3S / prusaslicer 2.6] CHANGE FILAMENT REQUEST DURING PRINT

[catlord21]

Hi,
I recently upgraded prusaslicer to 2.6 ( probably not related but I prefer leaving all information).
I'm printing litophanes with Overture professionnal white filament.

On my latest lithophane, At a random location ( begining of the print between 0 to 2h of print) I have a message to change the filament. once removed and put back, after a few minutes: same message.

there is no jamming, filament is going out nicely at change.

First time I have this trouble, only thing that has been changed is prusaslicer.

note : I checked the Gcode: no trace of M600 gcode

[prusa3d-bb]

Hello, thank you for your message. This is probably not related to Slicer. I would aim for the IR sensor mechanism. It would be best if you could open the extruder and make sure the IR sensor lever is returning to it's position properly. To be sure, here is the manual https://help.prusa3d.com/article/ir-filament-sensor-troubleshooting-mk2-5s-mk3s_112226 S pozdravem / Kind regards — Lukáš Vacek Customer Support PRUSA Research | Partyzánská 188/7a | 17000 Prague | CZ 00420 222 263 718 | SK 00421 220 570 305 — Your feedback is important to us! — Our 24/7 LiveChat help is available in our eshop at the right bottom corner. Troubleshooting tutorials here! Follow us on Twitter and Facebook! Check out our Blog! Have a look at our Service guides!

…

--- original message --- On August 8, 2023 at 3:12 PM GMT+2 ***@***.*** wrote: Hi, I recently upgraded prusaslicer to 2.6 ( probably not related but I prefer leaving all information). I'm printing litophanes with Overture professionnal white filament. On my latest lithophane, At a random location ( begining of the print between 0 to 2h of print) I have a message to change the filament. once removed and put back, after a few minutes: same message. there is no jamming, filament is going out nicely at change. First time I have this trouble, only thing that has been changed is prusaslicer. note : I checked the Gcode: no trace of M600 gcode — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.Message ID: ***@***.***> --- end of original message ---