Help with shutter control please

[pipa2493]

Hello.
please tell me what design should be used, and it is already confused...
I have no feedback from the motor....
2/0/0-telegram 0 (close), telegram 1 (open)
2/0/1-stop

[snowdd1]

What is the third line in the picture?

[pipa2493]

1 byte is the value for the position of the curtains, but do not use it because there is no feedback from the motor

[pipa2493]

use 1 bit to control.
Is it possible in homekit?

[snowdd1]

No. You need to specify the run times in ETS for your motor, so the actuator control can calculate run times to percentages.

[pipa2493]

Ok. Thanks. What about feedback?

[snowdd1]

For my GIRA actuators I can activate a feedback object that provides active feedback on the position the same way. So you have a set and a listen address. Look at the parameter configuration of your actuator.