Servo oscillation

[axg20202]

Any idea why my servo would start oscillating/jittering when extended? It has been working for a few months, so no parameters have been changed.

[tronfu]

Is your servo analog or digital?

…

On Jul 23, 2022, at 9:59 AM, axg20202 ***@***.***> wrote:  Any idea why my servo would start oscillating/jittering when extended? It has been working for a few months, so no parameters have been changed. — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.

[axg20202]

Hi. It's analog. It's an EMAX ES08MA II.

[axg20202]

I did have to lengthen the servo arm printed part by 8mm to get the dock to sit higher above my bed. Maybe that added length is causing the issue through too much wobble?

[tronfu]

That’s possible. I would try the shorter arm to see if the wobble goes away.

…

On Jul 25, 2022, at 2:51 AM, axg20202 ***@***.***> wrote:  I did have to lengthen the servo arm printed part by 8mm to get the dock to sit higher above my bed. Maybe that added length is causing the issue through too much wobble? — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you commented.