Pure MicroPython driver for the DRV8833 motor driver (intended for Adafruit's breakout board, but should work with any).
For a similar (and more thorough) driver but written in CircuitPython, see adafruit_circuitpython_motor.
Example usage (tested with an RPI Pico):
from machine import Pin, PWM
from drv8833 import DRV8833
from time import sleep
Pin("LED").on()
sleep(1)
Pin("LED").off()
# NOTE: feel free to play with the frequency value! The frequency (how many PWM cycles per second
# sent to the DRV pins) changes the behavior of the connected motors, especially at low throttle
# values. (based on very brief testing) We recommend values no lower than 1,000 and no higher than
# 200,000. 40,000 is a good default.
frequency = 40_000
# Make sure to set the correct pins!
ain1 = PWM(Pin(15, Pin.OUT))
ain2 = PWM(Pin(14, Pin.OUT))
bin1 = PWM(Pin(13, Pin.OUT))
bin2 = PWM(Pin(12, Pin.OUT))
ain1.freq(frequency)
ain2.freq(frequency)
bin1.freq(frequency)
bin2.freq(frequency)
drv = DRV8833(ain1, ain2, bin1, bin2)
throttle = 1.0
while throttle > -1.0:
drv.throttle_a(throttle)
drv.throttle_b(throttle)
sleep(0.1)
throttle -= 0.05
print(throttle)
drv.stop_a()
drv.stop_b()
# This will be called automatically when DRV8833 object leaves scope, but can be called manually if you want
# drv.deinit()