zigbee_offline_programmer

Demo

STM32F103C8T6 72MHz RAM:20K ROM:64K

• USART1: (DMA)download bin file to NXP zigbee

• USART2: debug(command line)

• USB: MSD(U flash disk)

  • 1. Save the configuration file (config.txt, set the automatic/manual download, maxium download times, download check, etc.)
  • 2. Save the bin(binary) file, and you can save more than one bin file, because you can configure the target bin file in the config.txt file.

• SPI1: SPI_FLASH(W25Q128)

• Since the STM32 (STM32F103C8T6) used in the test only has 20k RAM, which is not enough, so the sw button is used to make a choice when powering up and booting:

  • 1. If pressed, it runs U disk mode, which is recognized by the computer and used to change or view configuration information and modify the downloaded firmware.
  • 2. If not pressed, it runs download mode.

• Test board schematic: TestBoard_Schematic_Diagram_V0.1.pdf

• The config file demo：config.txt

1. Support Chip:

• NXP_JN5139
• NXP_JN5142
• NXP_JN5148
• NXP_JN5168
• NXP_JN5169

2. Features:

• Auto Program Mode
• Mannual Program Mode
• Max Program Control
• Verify After Program
• Run After Program
• Flash Read Out Protection

3. OTA:

NXP zigbee getway V3.0 ota, Convert bin file to ota file, check this project: nxp_zigbee_v3.0_ota