Raspberry Pi Weather Station
This repository contains the requisite python files I used to create my raspberry pi weather station. All hardware used in this build is listed below. You will also need items like solder and soldering iron which are not included below.
Hardware (most, if not all, items can be purchased on Amazon. I bought some items on Amazon and some from my local Micro Center)
Raspberry Pi 4 Model B 4GB
Samsung EVO Plus 32GB Micro SD card
4.7K Ohm resistor (x2)
Adafruit Perma-Proto HAT for Pi Mini Kit - No EEPROM
Adafruit MCP3008
Adafruit BME280
Sparkfun Weather Meter Kit
DGZZI 2PCS DS18B20 Stainless Steel Encapsulated Temperature Sensor Waterproof Digital Temperature Probe 1 Meter for Arduino
RJ11 6P6C Connector Breakout Board Module RA Screw terminals
Elenco Solid Hook-Up Wire Kit 6 Colors in a dispenser box # WK-106
Screw Terminal Block Kit 5mm Pitch 2, 3, 4 Pole (40 pcs) by QSU
When prototyping I also used the following items, but they were not used in the final build.
Breadboard
Jumper wires
GPIO Breakout Expansion Board and Ribbon Cable