iCON Platform M+

Support

Built-in

Introduction

Works very nicely, including 10-bit fader resolution and feedback for motorized faders and LEDs.

Tested with firmware v2.12.

Preparation

Please start the device in "Mackie" control mode (channel 1 since firmware version 2).

Important

"Mackie" mode is preferred over "User defined" mode, even if "User defined" by default transmits the same messages and therefore also just works. The significant difference is that "Mackie" mode supports the complete 10-bit fader resolution (1024 different values) whereas "User defined" mode uses only 7 bits (128 different values). It’s a complete mystery to me why they don’t use the full resolution in "User defined" mode. But that’s no problem, just make sure you use "Mackie" mode. It provides the best settings out of the box. Leave the customization to ReaLearn!

Presets

iCON Platform M+

Preferred because also provides a controller layout.

Mackie Control Universal

Also works but doesn’t offer a controller layout.