-
Notifications
You must be signed in to change notification settings - Fork 29
Home
Welcome to the i3_Berlin wiki!
These pages contain the full assembly manual to build and adjust your i3 Berlin through the following chapters:
Section 1: Introduction. About the history of this design and the power of open hardware.
Section 2: Assembly of the Y-Unit. The lower unit which holds the print platform.
Section 3: Assembly of the XZ-Unit. The vertical part that holds the extruder.
Section 4: Wiring. All the wires and where to put them, and you will join the two units.
Section 5: Calibration. See if everything works correctly and adjust it perfectly.
Section 6: Printing. How to use your printer and some tips to get started.
1 Introduction
1.1: History
1.2: Tools and Parts
1.3: Preparing the Casings
2 Assembly of the Y-Unit
2.1: Rods and Power Supply
2.2: Front- and Back- Plate
2.3: Mounting Y-Carriage and Belt
3 Assembly of the XZ-Unit
3.1: Mounting the X-Axis
3.2: Mounting the Z-Axis
3.3: Mounting the Timing Belt
3.4: Assembling the Extruder
4 Wiring
4.1: Wiring the Power Supply
4.2: Wiring the Z-Unit
4.3: Wiring the Y-Unit
4.4: Wiring the X-Axis
4.5: Gluing the Endstop Magnets
4.6: Uploading Firmware
4.7: Wiring the Extruder
4.8: Mounting the Heatbed
5 Calibration
5.1: Testing Functionality
5.2: Calibrating the Y Axis
5.3: Calibrating the X Axis
5.4: Calibrating the Print Platform
6 Printing
6.1: Filament Holder
6.2: Cura
6.3: Kisslicer
6.4: Dual Printing